[CAUT] sizing key-frame pin holes?

[Roger Jolly]

---------------------- multipart/alternative attachment

Hi Mark,
                 Size with CA it works fine.  We replace pins regularly.  I 
push the new pins in, on the drill press, with the quill set to the right 
depth.  'Use a piece of 1/4" rod with a dimple drilled in the end of 
it.  Works great every time.
Regards roger



At 05:44 PM 8/30/2004, you wrote:
>we're having to replace a set of nicked .146" front-rail pins and have
>replacements on hand, however, the new ones are a loose fit in the original
>holes.
>
>i.e.: not wobbly, but they can be pushed in and turned with bare hands.
>
>I was thinking of pre-sizing the holes with hide glue ... any
>cautions/suggestions?
>
>thanks,
>Mark Cramer,
>Brandon University
>
>_______________________________________________
>caut list info: https://www.moypiano.com/resources/#archives

---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/caut.php/attachments/4c/55/24/31/attachment.htm

---------------------- multipart/alternative attachment--