[CAUT] gorilla glue

Wigent, Donald E WIGENTD at ECU.EDU
Thu Nov 9 09:31:30 MST 2006


Say gang: tell me about this glue, Can I handle it or is it like CA and
would it be good for cracked bridges. What is it good for? Maybe broken
leggs or ripped out lid hinges? 

Don Wigent

E C U

 

________________________________

From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of
Jim Busby
Sent: Wednesday, November 08, 2006 1:31 PM
To: College and University Technicians
Subject: Re: [CAUT] gorilla glue

 

Thanks Dale. Of course, I was hoping you'd have some magic solvent or
voodoo for me. What an awful glue...

 

Jim Busby BYU

 

________________________________

From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of
Ward & Probst, Inc
Sent: Wednesday, November 08, 2006 10:15 AM
To: 'College and University Technicians'
Subject: Re: [CAUT] gorilla glue

 

Jim,

 

I think you'll have to cut the hammers off to save the shanks. I'd use a
band saw to remove as much as possible. then whittle off the rest. I am
pretty sure that poly glue is not susceptible to solvents after it sets.
All that said, you'd have enough time in the job to have to weigh it
against the cost of new parts, particularly if the original parts need
repining, etc. I'd guess it'd would take two to three hours to clean up
the old shanks. Unless they are unusual or costly shanks, that would be
at least half the way to new parts.

 

Good luck,

Dale

Dale E. Probst, RPT

Ward & Probst, Inc.

Wichita Falls, TX 

mailto:dale at wardprobst.com

www.wardprobst.com <http://www.wardprobst.com/> 

 

	-----Original Message-----
	From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On
Behalf Of Jim Busby
	Sent: Wednesday, November 08, 2006 10:36 AM
	To: College and University Technicians
	Subject: [CAUT] gorilla glue

	List,

	 

	All the talk of glue brings me to this problem/question. Someone
used gorilla glue to hang some hammers that I want to remove and I can't
find ANYTHING that will work. I know I could simply buy new shanks and
flanges, but does anyone know of anything that's works on this stuff??

	 

	Thanks.

	 

	Jim Busby BYU

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/caut.php/attachments/20061109/bcdec64a/attachment.html 


More information about the caut mailing list

This PTG archive page provided courtesy of Moy Piano Service, LLC