That shoots my theory of a bad batch of material down. John M. Ross Windsor, Nova Scotia, Canada jrpiano at win.eastlink.ca ----- Original Message ----- From: Karen Lindsley To: College and University Technicians Sent: Tuesday, November 13, 2007 11:30 PM Subject: Re: [CAUT] breaking strings Sorry for the confusion; you are right that the strings are not breaking at the becket but at the bottom of the coil. I will check the speaking length next time I go to visit the piano and compare with a more modern piano. Once again, thanks for your input. It is really nice to be able to post a question and get so many answers back. Karen On 11/13/07, A440A at aol.com <A440A at aol.com> wrote: << The breakage occurs at the becket, and usually in the upper 5th and the 6th octaves. >> Um, at the becket? Or, at the coil. It is really rare for a string to break at the becket, unless it has been taken off and put back on while flexing the becket. If it is breaking at the bottom of the coil, then it has either been tuned a lot or there is excessive friction between the pin and the speaking length, necessitating abnormally high tensions just to render the strings. So, were these strings breaking at the bend where it enters the pin? confused, Ed Foote ************************************** See what's new at http://www.aol.com -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/20071114/150bf687/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC