[CAUT] S&S hammer flange rail material and cheap mylar

[Alan McCoy]

Hi Folks,

I've used a variety of materials for this application. I'm about to put on
another set of S&F and wanted to hear what other techs are using. I've been
searching the fabric stores to find a good material with no success yet. I'm
thinking wool or cotton with some body to it. The strips from S&S are $8
each. Being cheap, I'd like to be able to do 5 actions for $8 and figure I
can do that if I find the right fabric.

Speaking of finding something cheap. I called around last month to try to
find a roll of Mylar. I called a local graphics supply store and they
happened to have a "damaged" roll of mylar (core was very slightly
flattened) that they would sell to me for $5. The roll is something like 30"
by 150 feet, which would normally sell for more than $100. That's a lot of
bridge patterns! So if you're looking for some mylar, you might search
around for "damaged" rolls. Apparently if the cardboard core is flattened
slightly the roll can't be used in machines.

Thanks for your thoughts.

Alan


-- Alan McCoy, RPT
Eastern Washington University
amccoy at mail.ewu.edu
509-359-4627
509-999-9512