David, Before gluing these riblets do you wedge up the soundboard or lower string tension? Albert Lord. On Tue, Mar 31, 2009 at 11:50 AM, Porritt, David <dporritt at mail.smu.edu>wrote: > > > The riblets helped both power and sustain. To be sure I was going to be > screwing the anchor screw into the bridge I drilled a very small pilot hole > down through the bridge. I put both holes spaced between two ribs and > drilled so the screws would go between unisons and would not interest bridge > pins. Then from underneath I scrapped the lacquer off the sounding board > where the riblets would be glued to it. I then applied glue and screwed > them on. > ------------------------------ > David M. Porritt, RPT ** > > > > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/caut_ptg.org/attachments/20090331/c121fc74/attachment.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC