This may seem simplistic, and please don't take offence, but have you wound the drop screws out a ways so you can get a clear shot at what let off is doing ? P Sent from my iPhone On May 27, 2010, at 7:54 AM, Paul T Williams <pwilliams4 at unlnotes.unl.edu > wrote: > Hi all, > > It's been years since I bored my own hammers and need a number. > What is a proper bore distance for a Steinway L (1924). I installed > some Abel Naturals last fall and the project went on hold while the > piano got a new board and bridges. I just measured A-0 and it's > 2-1/8". I'm trying to regulated the action and am having a tough > time for some reason. > > The key level and dip is factory perfect, I've got the proper blow > distance of 1.75". I can't get let off any closer than 1/4"!! The > rebuild was done right and the plate is the same height as before. > I've even tried to raise the blow a bit, and still can't get it to > let off correctly. The frame is perfectly bedded. The wips are old, > but in pretty good shape. I started at A-0 and only tried 5-6 notes > before writing yall. > > I'm wondering what's going on. Any thoughts of what to check next? > > Paul -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/caut.php/attachments/20100527/89991461/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC