On 2/20/2011 7:33 PM, Delwin D Fandrich wrote: > Mine shows it a little lower but still higher than I'd consider safe. > > Considered switching from a wrapped bi-chord to a plain steel tri-chord? > According to my spreadsheet this might actually work better. F#-3 (note 34, > right?) with a length of 865 mm and plain wire of 0.041" to 0.043" diameter > looks acceptable depending, of course, on what is above and below. > > ddf Yes, that would have been nice, if not for the 3 or 4 wrapped bichords above it, tuning pin and hitch count and placement. Unfortunately, fixing it isn't in the cards, just minimal tuning recovery. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC