At 12:38 AM 8/29/98 -0500, you wrote: > >Roger has the idea, but didn't go far enough. Hie thee to the nearest >automotive supply store and purchase the cheapest impact dent puller you can >find. Get rid of the screw end, and possibly the shaft, and save the weight. >Cannibalize a small vise grip by removing the adjustable screw from the >back. Thread the dent puller shaft, if it's the right size - a suitably > > Ron > > Possibly a use finally for my impact coli lifter (with a split collar) as Joe suggested too. The thread is too large for my various pairs of vise grips but an appropriately sized shoulder bolt from the hardware store and the metal weight should do to trick. Now, where's a bridge pin . . . let me at 'em . . . Jon Page Harwich Port, Cape Cod, Mass. (jpage@capecod.net) ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This PTG archive page provided courtesy of Moy Piano Service, LLC