I own a real nice Makita saber saw.... It has a nice long stroke and the Makita blades are very good. I have used it for nearly 15 years and cut everything from pin blocks to van windows.... I have now idea about it's replacement cost. Mike Swendsen RPT -----Original Message----- From: owner-pianotech@ptg.org [mailto:owner-pianotech@ptg.org] On Behalf Of JIMRPT@aol.com Sent: Monday, August 31, 1998 9:35 AM To: pianotech@ptg.org Subject: Sabre Saw??'s et al; I am getting ready to purchase a replacement for my sabre saw....the small kind not the large ones for cutting timbers....... Since this one lasted 17 years and cut, probably, numerous thousands of board feet of maple/mah/birch/oak, etc., I am not familiar with what is currently available. My records indicate I paid 37.95 for it back in 1981 so I suppose I can't complain about its longevity or economy huh? ( I had to buy this one to replace a four thousand pound :-), seemed like it anyway, Milwaukee that could not stand up to the challenge of being dropped off of a thirty five foot scaffold onto bare concrete.) Any suggestions? Jim Bryant (FL)
This PTG archive page provided courtesy of Moy Piano Service, LLC