sanding block

[Joe & Penny Goss]

Thanks Don. This time I put it down in the resource guide.
Joe

----------
> From: Don <drose@dlcwest.com>
> To: pianotech@ptg.org
> Subject: Re: sanding block
> Date: Sunday, June 28, 1998 5:01 PM
> 
> Hi,
> 
> Try Chris Gregg,cgregg@huey.cadvision.com (this may be an old email addy)
> 
> 
> At 04:38 PM 6/28/98 -0600, you wrote:
> >List,
> >Does anyone know the name and address of the maker of the voicing
sanding
> >block?
> >It has four different sides so one can sand the center string , outer
> >string , two strings  or all so that the hammer is level to the strings.
> >Thanks Joe Goss
> >You know your on the level if your bubble is in the middle.
> >
> >
> Regards,
> Don Rose, B.Mus., A.M.U.S., A.MUS., R.M.T., R.P.T.
> "Tuner for the Centre of the Arts"
> drose@dlcwest.com
> http://www.dlcwest.com/~drose/
> 3004 Grant Rd.
> REGINA, SK
> S4S 5G7
> 306-352-3620 or 1-888-29t-uner
>