In a message dated 98-10-15 23:46:18 EDT, you write: << I have recently purchased a SATII and have enjoyed using it, however, as I read articles and the manual I am confused as to the proper use of the machine. How do some of you use your SAT? Do you start from A0, after FAC readings, and tune each note to the top, unisons as you go? Do you set a Temperament with the machine and tune up and then down? Just what do some of you do? I want to get the best tuning I can and have used a couple of these methods but don't know which is best. Jere Fryett PTG Associate >> I combine my aural abilities with the use of the SAT. Set your FAC readings, then check your A4 to be sure it is A-440. I do this by tuning A4 with FAC chart then hit shift-reset to clear, then in tune mode check A4. If the lights stop properly, then its ok. If not, tune to A4 in the tune mode then check in the FAC mode. If the A4 lights move, then set the cents up or down until the lights stop and then hit shift-sto mem. This reading will reflect A-440 in the FAC mode. Then go to the lowest note of the temperament octave and tune up the scale using aural checks.The farther you go, the more checks you have. Dave Peake, RPT Portland, OR
This PTG archive page provided courtesy of Moy Piano Service, LLC