Richard, list: A few have asked about the cutters I use on my Dremel tool. The bit is part #614, priced about $10.00. I took this bit (1/8" shank) to the local bearing supplier, and they gave me a bearing off the shelf which fit perfectly. The inside diameter is 1/8", width is about 1/4" and outer diameter is about 1/2" (I didnt measure it). As I said before, I glued the bearing to the bit with threadlock. No, it doesn't burn, and cuts cleanly. It's easier than using a big router to do this simple job. Paul McCloud
This PTG archive page provided courtesy of Moy Piano Service, LLC