I carry a "glue box", it's an insulated lunch bag,about the size of a six-pack. The insulation helps keep the temp. of the contents more stable. Inside is a square tupper-ware type container that divides the box into compartments. Then I try to purchase small bottles of whatever and sometimes use veterinary hypodermic needles as applicators (nip sharp point with wire cutters). Other useful applicators are a rubber ear syringe, q-tips, paint brushes.... Diane >From: "Paul S. Larudee" <larudee@pacbell.net> >Reply-To: pianotech@ptg.org >To: pianotech@ptg.org >Subject: Re: transporting lubricants and adhesives >Date: Mon, 06 Dec 1999 07:28:12 -0800 > >bases-loaded@juno.com wrote: > > > > Hello- > > > > Has anyone mastered a method for transporting the array of liquids we >use > > to the job site in a way that makes them easy to use on site, yet not > > worry about spillage in the tool kit - remaining upright, proper nozzles > > in place, etc.. > > > > I have been trying a variety of methods, none totally satisfactory, and > > am considering purchasing a dozen 2 oz plastic bottles of like height >and > > making a separate custom tool box for transport. > > > > Any ideas? > > > > Mark Potter > > bases-loaded@juno.com > >Pacific sells syringe bottles that don't leak and have a good cap on the >syringe. I also keep all liquids in a boating/camping case that is >leakproof. The Pacific bottles are very small and I would love to hear >about bigger ones if they exist. > >Paul S. Larudee, RPT >Richmond, CA ______________________________________________________ Get Your Private, Free Email at http://www.hotmail.com
This PTG archive page provided courtesy of Moy Piano Service, LLC