Use new thin CA and a tiny holed applicator to apply CA to the slanted side until there is a meniscus. Move on to the pin until about an octave has been done. Return to the first pin and apply again. Continue so until there is a meniscus that does not disappear. The entire hole will be filled by CA and pin. Use a facial tissue to wick up the excess. Allow to set for 24 hours or so. Do not remove the pins. Also check the archives at http://www.ptg.org/archive/pianotech.php/ Search for split bridges, loose bridge pins and other parameters you can think of. Also use the <edit><>Find> buttons to find specific strings in that archive. Newton
This PTG archive page provided courtesy of Moy Piano Service, LLC