Paul I didn't catch this at first. If the #7 bridge pin is "every tight" you probably used the wrong thickness of bushing cloth. The pin should slide through with about 2-3 grams of resistance. Test your current work with a clean damper wire. If it slides though with no resistance, I'd say you'll probably be ok. Yamaha fits theirs this way. I can't tell you what cloth or thickness they use, but we have very little trouble with their dampers. Paul Chick ----- Original Message ----- From: Paul McCloud <smccloud@ix.netcom.com> To: <pianotech@ptg.org> Sent: Friday, September 29, 2000 10:54 AM Subject: Re: Rebushing S&S Damper Rail > Paul: > I am just finishing my rebush job, using two strips of felt. I was > wondering, since I sized the holes with a bridge pin, and the pin is > very tight, will the hole close up after some time and moisture > changes? I fear that although the holes are just right now, maybe I'll > be doing some bushings again in the future. > Paul McCloud >
This PTG archive page provided courtesy of Moy Piano Service, LLC