Sagging pinblock

[Newton Hunt]

Hi Bill,

Good to se you again so soon.

I would tighten the plate screws in the middle section then
use a pinblock jack to put pressure on the block and see if
you can get the screws to move again.  It may well be the
block and plate are mated together under the webbing of the
plate but they may not be.  I had a S&S D once that had this
problem and it would NOT stay in tune long.  Tightened the
screws and it was much more stable.

Care must be taken and a lot of thought given to the
possibility of the plate cracking.

Also, if it ain't broke don' fixit.

		Newton