ATTN; Dyna2 testers

[gutlo]

You should all be receiving your samples via FedEx by the end of the week. 
Following are some suggestions for your test:

1.  Put on a very thin coat, let it sit for an hour.  You might just take
off the finish, leaving the paste wood filler.
2.  Use only a natural bristle brush to apply.  A nylon brush doesn't allow
an even coat.
3.  Don't forget to try it on a vertical surface - no drip or sag.
4.  Wait overnight before sanding to prevent gumming up the sandpaper.

Post your results on the list.

Thanks for your time and trouble.

Arthur Grudko
StarHawk Labs