Tuning Lever Ball

[Kent Swafford]

on 1/25/01 6:11 AM, Clyde Hollinger at cedel@supernet.com wrote:

> Dave,
> 
> At the exhibitor where I saw these, the hole in the ball was way too big to
> fit well on any of the tuning hammers that were on display.  I pointed this
> out to the salesman and also to several standers-by, and no one knew what to
> say.  So be sure to get one that fits right.
> 
> Regards,
> Clyde Hollinger

The hole's being too big is easier to deal with than the hole's being too
small. I used paper-backed veneer to shim the hole of a ball to the proper
size for a back-up hammer on which I wanted to put a ball. Works great.

Kent Swafford