---------------------- multipart/alternative attachment Hi David, I'm having a chuckle, I discovered the same thing in a similar manner, only I was waiting for some damper felt on back order. Been doing that way for a number of years. On a rebuild I always pull, and service, the back action. Even with screwed flanges it is a hassle getting at them, when every thing is assembled.. Another time saver: align the back action to the keys with the stack off, and no strings on the piano. Perfect unacorda every time. Regards Roger At 04:30 PM 3/5/01 -0800, you wrote: > > List, > > So I'm here in the shop finishing up a Steinway M. I noticed a wobbly damper > lever (dampers already rough regulated). I put it off until finally I > decided I couldn't leave it. I pulled the dampers and the underlever system > to fix the problem. Pinning was loose so I popped off the lever/flange and > repinned and then reglued and clamped. I looked at back at the piano and > thought..."Hey this would be a good time to finish up the let-off!" So I > installed the action and found I was able to align the hammers, do > let-off/drop, level strings and whatever I can think of. WOW! This is the > way to do it if your rebuilding a grand. Restring, hang your hammers rebuild > action, whatever and then regulate the action with the dampers out of the > way. Install your dampers at the end of the job...this is probably common > knowledge to everyone except me (and I've thought of it but never actually > did it)but if anyone hasn't tried this give it a shot! > > David Ilvedson, RPT > ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/b9/43/3f/94/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC