Jon, I've not seen a geared one, but in a parts catalog they have a Multi angle screwdriver, a shaft with a cube at the end, and ground into each side is a slot at different angles | / \ and -- if text makes the picture for you Brian Lawson, RPT Johannesburg, South Africa TEXOMA CHAPTER http://texoma.int.chapter.tripod.com ----- Original Message ----- From: "Jon Page" <jonpage@mediaone.net> To: <pianotech@ptg.org> Sent: Sunday, March 18, 2001 7:30 PM Subject: Off-set screw driver > I'm tediously adjusting the front and rear screws on a rocker arm action > to set a hammer line. > > Does anyone know of a geared 90 degree driver which would facilitate > this task? > > I have an off set screw driver and a ratchet offset driver but something > with greater turning capabilities and easier placement would be welcome. > > Regards, > Jon Page, piano technician > Harwich Port, Cape Cod, Mass. > mailto:jonpage@mediaone.net > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ >
This PTG archive page provided courtesy of Moy Piano Service, LLC