---------------------- multipart/alternative attachment Nails work just fine but you should solder it in place. David I. *********** REPLY SEPARATOR *********** On 5/2/01 at 6:19 PM Ray T. Bentley wrote: Fellow Pianotechs around the planet: How do you repair a broken damper rod hook? I had two of them silver soldered by someone else. One has lasted for many years. But the most recent one only held for about 4 weeks. One my mentors from way back told of using a smooth nail of the correct diameter bent at a 90 degree angle fitted into the rod. Schaff has replacement pins which are straight. I assume they have to be bent after installation. They're very inexpensive, but a minimum order would have to be placed. Has anyone else tried the nail approach? Any other suggestions? Thanks for any ideas! Ray T. Bentley, RPT Alton, IL Ray@Bentley.net www.ray.bentley.net "The difficult I do right away; the impossible takes a little longer!" ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/0e/f8/b3/55/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC