Ooops! Did I boo-boo? Are the Schaff standard cheepie pinblocks not rotary cut? Terry Farrell Piano Tuning & Service Tampa, Florida mfarrel2@tampabay.rr.com ----- Original Message ----- From: "Ron Nossaman" <RNossaman@KSCABLE.com> To: <Pianotech@ptg.org> Sent: Friday, May 04, 2001 12:58 AM Subject: RC PB laminations > Noticing that Terry Farrell called the 9 ply Schaff pinblock rotary cut and > got away with it (way to go Terry), I have an appropriate observation made > fresh this afternoon. > > Tuning a Conn console (A051C9744), I took a look at the pinblock and found > a 9 ply ROTARY cut block. No mistake, it is clearly rotary cut stock. > Laminations were about 3mm each, and pin torque was a little on the high > side and quite uniform throughout. Old biases and performance evidence > toward quarter cut solid stock for thick ply pinblocks and bridge capping > seem less valid every day in close laminated stock for the same uses. The > boil test can go fish. > > Truths change on you when you aren't looking. > > > Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC