Carl, It came with 3 "tips". 1."finish nail": @.2000" ID 2. "Magnetic tip": @.4500", which is ok diameter, but don't want magnetized tuning pins! 3. "Standard tip: .5000", which is too darned big! Could you tell me the size of the "tip" you use? Regards, Joe Garrett ----- Original Message ----- From: "Carl Meyer" <cmpiano@home.com> To: <pianotech@ptg.org> Sent: Monday, May 07, 2001 2:25 PM Subject: Re: Air Hammer > > Joe! Just what exactly is the ID of the tip you have on your air hammer? > > Carl Meyer > > ----- Original Message ----- > From: Joseph Garrett <joegarrett@earthlink.net> > To: <pianotech@ptg.org> > Sent: Sunday, May 06, 2001 11:32 PM > Subject: Re: Air Hammer > > > > Bought one of these at that price. Still trying to figure out how it > works. > > There were no tips that would fit over a tuning pin, so I'll probably have > > to have a special one made. So much for bargains. :-( I suspect, after > > checking the Danair website, that I should have bought on of those! > > Regards, > > Joe Garrett > > ----- Original Message ----- > > From: "Carl Meyer" <cmpiano@home.com> > > To: <pianotech@ptg.org> > > Sent: Sunday, May 06, 2001 8:01 PM > > Subject: Re: Air Hammer > > > > > > > > > > Murphy's law strikes again!!! Whenever you buy something, it always is > on > > > sale somewhere else cheaper!!!! > > > > > > Oh well. It's only money, > > > > > > Carl Meyer > > > > > > ----- Original Message ----- > > > From: Ron Lindquist <ronli@newnorth.net> > > > To: <pianotech@ptg.org> > > > Sent: Sunday, May 06, 2001 7:25 AM > > > Subject: Air Hammer > > > > > > > > > > Harbor Freight Tools has a nice one on sale for $49.95--I got one when > > > they > > > > were $79. > > > > <harborfreight.com> or 800-423-2567. > > > > > > > > > > > > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC