Toto, Ouch, I hate it when that happens! IMHO a plug would be the best. Joe Garrett, R.P.T. ----- Original Message ----- From: <toto@fovea.pndr.upenn.edu> To: <pianotech@ptg.org> Cc: <toto@fovea.pndr.upenn.edu> Sent: Wednesday, May 09, 2001 7:22 AM Subject: pinblock hole alignment > > > Misaligned pinblock hole: > > I just finished drilling out a pinblock (Bolduc) for a grand. One > hole (in the bass) ended up misaligned so that the edge of the hole > is slightly under the plate (about 1/128th inch) on the agraffe side. > I see two options: 1) plug and redrill 2) file the bottom edge of > the plate hole to prevent the pin contacting the plate. (The holes > were drilled at a 5 degree angle.) I will be using bushings. > > Any advice? > > Thanks, > Larry Toto >
This PTG archive page provided courtesy of Moy Piano Service, LLC