---------------------- multipart/alternative attachment At 05:53 PM 05/09/2001 -0500, you wrote: >David >I always drill through the pin bushings with the plate and pinblock in the >piano. The holes are always in line. >Paul Chick If you don't have the setup for drilling in the piano, you can drill the bushings in the plate. Once the bushings are installed, remove the plate, drill from the bottom at the angle at which the block was drilled. This will ensure a better alignment. Regards, Jon Page, piano technician Harwich Port, Cape Cod, Mass. mailto:jonpage@mediaone.net http://www.stanwoodpiano.com ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/11/dc/7f/2b/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC