And I just restrung a piano with 2/0 pins and first used my old shop hammer for chipping. I noticed that the tip seemed loose, so I tried my old Randy Potter student hammer - it sat too high on the pin. So I got out my daily-use hammer from my case - it fit perfectly. All tips are indicated to be #2 tips. Go figure. ----- Original Message ----- From: "Joseph Garrett" <joegarrett@earthlink.net> To: <pianotech@ptg.org> Sent: Thursday, May 17, 2001 11:24 PM Subject: Tuning pin size? > Ron & List, > My question was and still is, does anyone know when and how did the > industries decide on the diameter of tuning pins? > Another question that's bugged me for years: Why is it that some > manufacturers 2/0 tuning pins are too big for a standard #2 tip, while some > are too small and others are just right? (Hmmmm! sounds like Goldilocks had > something to do with that!) :-) > Regards, > Joe Garrett > P.S. > An afterthought: Maybe Jack Wyatt might know about this stuff. Jack? >
This PTG archive page provided courtesy of Moy Piano Service, LLC