_I_ sort them by pin tightness. Newton Richard Brekne wrote: > > Lots of factories sort their shanks by the sound they make, and some even > file shanks to conform to some frequency. I have been curious about this > kind of thing for quite some time, but have never managed to find out much > about it. Hammer shank voicing I have heard this procedure called. > > "Robert A. Anderson" wrote: > > > I bought a set of Brooks "Encore" sh & fl recently. When I opened the > > box, I was surprised to see that the whole set had narrowed shanks. I've > > heard one comment to the effect that this was an improvement that > > cleared up some tonal problems in the bass. I haven't hung the hammers > > yet, so I don't have any impressions to offer. I wonder if any of you > > have had any experience with these shanks that you would share with the > > list? > > > > Bob Anderson > > Tucson, AZ > > -- > Richard Brekne > RPT, N.P.T.F. > Bergen, Norway > mailto:rbrekne@broadpark.no
This PTG archive page provided courtesy of Moy Piano Service, LLC