It is lighter gauge wire... David I. *********** REPLY SEPARATOR *********** On 5/28/01 at 10:34 PM Farrell wrote: >I have done this repair a number of times - always on older Steinways. I >guess that is part of my justification for using CA - its an older action >and, hopefully, the piano will not have that set of wippens for ever. I >also >remove the wippen from its rail - so quick on a Steinway - so as to not >risk >getting any on keys, etc. Then applying the glue to the removed tender, and >using medium viscosity, pretty well eliminates the risk of getting the >nasty >glue anywhere you don't want it to go. But you are correct in pointing out >that there would always be a risk. > >Is it not true that the rep spring on C88 is not only adjusted lighter to >accomodate the lighter hammer than in the middle of the keyboard, but also >the spring wire itself is a heavier guage - or something about the >construction of the spring is different - such that simply exchanging >wippens and adjusting spring tension would not be ideal? > >----- Original Message ----- >From: <Wimblees@AOL.COM> >To: <pianotech@ptg.org> >Sent: Monday, May 28, 2001 7:16 PM >Subject: Re: Kahane piano breakdown > > >> In a message dated 5/28/01 4:45:02 PM Central Daylight Time, >> mfarrel2@tampabay.rr.com writes: >> >> << Pull tender off jack, place drop of medium viscosity CA glue on tender >tip, >> insert and be sure glue is spread around, then a quick shot of kicker - >be >> sure glue does not migrate to birdseye or elsewhere. >> >> >> This is the reason I would hesitate to use the CA glue. Yes, it is a good >> quick fix, but if you make a mistake, and under the circumstances, it >would >> be very easy to get nervous and make a mistake, you could render the >wippen >> useless, and then you would have to switch wippens any way. >> >> Willem u
This PTG archive page provided courtesy of Moy Piano Service, LLC