Thanks, Paul. I'll add this to my options for travelling the path of least resistance. Mark Potter bases-loaded@juno.com On Wed, 17 Oct 2001 07:24:46 -0500 "Paul" <tunenbww@clear.lakes.com> writes: > Mark > I just did one of these. I added a shim behind the stop block on the > bass > side of the key frame, made minor adjustments to align hammers to > strings, > took up the lost motion of the una corda pedal, reset the stop screw > on the > treble side of the key frame. Test all keys with una corda pedal > depressed. > There is a tendency for some of the keys to pick up an adjacent > damper > lever. > > Paul Chick > ----- Original Message ----- > From: <bases-loaded@juno.com> > To: <pianotech@ptg.org> > Sent: Tuesday, October 16, 2001 2:09 PM > Subject: Steinway hammer alignment > > > > Greetings - > > > > First service call to a new customer. 1976 vintage Steinway S. > More > > than 2/3 of the hammers are striking left of center, although they > ARE > > square to the string plane. It is clear they have been this way > since > > day one. > > > > The Steinway rail does not allow enough play to simply loosen the > hammer > > flange screws so that the hammers can be moved over to the right > enough > > to be centered. I had to use the soft pedal constantly in order > to sound > > the majority of the right hand strings for tuning. > > > > What have some of you found to be the best solution for this > problem? I > > must say I have never run into such rampant misalignment, and find > it > > hard to believe it has not been noticed and dealt with by now. > > > > Thanks for any input! > > > > Mark Potter > > bases-loaded@juno.com > > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC