Hi Joe. Are you describing a screw that goes into the key, but the head is located under the action cloth? That would present a bit of trouble to adjust, would it not? How would one go about adjusting such a set-up? I did not notice that any of the action cloth pieces were elevated - they all appeared to be glued to the wood on top of the key - but I was not looking for a screw under there. I'll look next time I tune (hmmm, let's see, I gave it a 150 cent pitch raise last time, so I would guess she tunes about....what, every 50 years or so?). Thanks Joe. Terry Farrell ----- Original Message ----- From: "Joseph Garrett" <joegarrett@earthlink.net> To: <pianotech@ptg.org> Sent: Saturday, September 22, 2001 11:16 PM Subject: Emerson > Terry, > Check to see if there is a flat head screw under the key/contact felt. > Regards, > Joe Garrett >
This PTG archive page provided courtesy of Moy Piano Service, LLC