This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment ----- Original Message -----=20 From: Tom Servinsky=20 To: pianotech@ptg.org=20 Sent: September 27, 2001 1:46 PM Subject: Re: Tensioned hammers and "the staple" Del, Have you had any problems with the Renner hammer ( non-stapled) = pulling apart in high humidity regions. In S. Florida I have had 5 sets = that we installed pulled apart. Obviously the problems were in the low = tenor and bass and not the top 1/3 of the piano, which I'm assuming is = why you stop where you do. I too have found that the reduction in touch = weight far outweighs any concerns for separation in that portion of the = instrument. But as a safe-guard for me, wires throughout the rest of the = piano are mandatory. Tom Servinsky,RPT -------------------------------------------------------------------------= ----- Tom,=20 I haven't used Renner hammers for years. They are far to hard and dense = for anything we do. It would be impossible to soften them enough using = any technique known to the modern world. We use unlacquered Isaacs and = unlacquered S&S hammers with a few unlacquered Ronsen's thrown in from = time to time. Del ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/59/60/77/b8/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC