Hygrometer

[Farrell]

The operative word is "relatively" low cost. One can go to a medical/nuclear laboratory supply house and I'm sure find a real nice hygrometer for $30K. I do expect to pay more than the $30 for the Radio Shack hygronimus inaccuratus. Many 2% accuracy units are available in the few hundred $$ to $1K range. I was hoping to find a recommendation for a unit that performs well, and is in the lower end of this cost range.

Doesn't anyone use a good hygrometer? Do y'all just stick a board in the oven until it is light brown and slightly crisp? Or can you make it pop up at the proper time? Maybe one of those little pop-up buttons like on a Butterball?

Terry Farrell
  
----- Original Message ----- 
From: <HazenBannister@cs.com>
To: <pianotech@ptg.org>
Sent: Thursday, August 29, 2002 10:28 PM
Subject: Re: Hygrometer


> In a message dated 08/29/2002 9:02:25 AM Eastern Daylight Time, 
> mfarrel2@tampabay.rr.com writes:
> 
> 
> > relatively low
> > > > cost, high accuracy 
> > 
> Terry,
> After thinking it over, I don't think these two phrases go together,or at 
> least when I get ready to buy something.
> Best,
> Hazen Bannister
>