10mm = 1 3/4 inch blow

[Richard Brekne]

I dont think so Richard.

Its not like blow / dip are directly dependant on Key Ratio alone. There
are two other levers involved their ratios are going to influence what
happens for X amount of capstan move. 

RicB



Richard Moody wrote:
> 
> 
> If you wanted a 1-7/8 blow from the 10 mm dip, how far would have
> to move the capstan and which way I assume towards the back check.
> What I am getting at is there a chart what will show for every mm
> the capstan is moved the hammer will go up x mm ?  Does anyone
> have a formula I can plug into my spread sheet?    ---rm
> 
>
Richard Brekne
RPT, N.P.T.F.
UiB, Bergen, Norway
mailto:rbrekne@broadpark.no
http://home.broadpark.no/~rbrekne/ricmain.html