Jointech vs. Incra

[Greg Newell]

Paul,
    Thanks again for taking the time to write! Incra has the micro - adjust knob
on the rail vs. Jointech's on the fence. It seems as there is not a great deal
of difference between the two except maybe for price. Thank for your help!

Greg

"Paul Chick (EarthLink)" wrote:

> Greg
> The Jointech fence that I bought is more ridgid than the Incra that I had.
> When it is locked down, it provides a stiffer fence for stock to run
> against.  Also, it has a rotating knob on the fence adjustment that allows
> for very fine settings, to within a thousandth of an inch very easily. This
> proved to be very helpful when correcting a cut joint, like a dovetail, that
> turned out too tight or loose.  I've use it on my saw table, router table,
> and can see using it on my band saw.
>
> Paul Chick
> ----- Original Message -----
> From: "Greg Newell" ?gnewell@ameritech.net?
> To: ?pianotech@ptg.org?
> Sent: Monday, February 04, 2002 2:48 PM
> Subject: Re: Jointech vs. Incra
>
> ? Paul,
> ?     Thank you for responding. So few have. Since you have tried and used
> both
> ? could you expound a bit more about what you liked or disliked about each
> one?
> ? I'd greatly appreciate it.
> ?
> ? Greg

--
Greg Newell
mailto:gnewell@ameritech.net