This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment ----- Original Message -----=20 From: David Love=20 To: Pianotech=20 Sent: February 22, 2002 6:16 PM Subject: Bass bearing bar I have to remake a wooden bass bearing bar for an old upright (tuning = pin side). What is the correct angle that the grain should run? Seems = straight forward on appearance, any comments? David Love Make it out of Delignet or, better yet, scrap Baldwin pinblock stock. = Gluelines run parallel to the plate. Much better than solid wood in this = application. Del ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/70/69/23/68/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC