Laying Down on the Job

[Tony Caught]

This is a multi-part message in MIME format.

---------------------- multipart/alternative attachment
There was once when all I could find was a socket set. 1/4". You use a =
1/4" socket reversed so that the octagonal grip fits onto the socket and =
the 4 sided section fits over the pin. In desperation we can do =
anything.

Regards

Tony Caught
caute@optusnet.com.au

  ----- Original Message -----=20
  From: JIMRPT@aol.com=20
  To: pianotech@ptg.org=20
  Sent: Wednesday, October 02, 2002 11:52 PM
  Subject: Re: Laying Down on the Job



  In a message dated 02/10/02 9:35:58 AM, tomtuner@attbi.com writes:

  << You don't tune with a socket wrench do you.

              Best wishes,

              Tom Driscoll >>

  No, not a "socket wrench" ... but I have tuned with a pair of vise =
grips....=20
  :-)
  Jim Bryant (FL)
  _______________________________________________
  pianotech list info: https://www.moypiano.com/resources/#archives

---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/2b/64/a3/ba/attachment.htm

---------------------- multipart/alternative attachment--