I H hope you will post how to regulate these knuckles. I do not want to wait for the journal article. Thanks Bill Peterson ----- Original Message ----- From: Joseph Garrett <joegarrett@earthlink.net> To: <pianotech@ptg.org> Sent: Tuesday, October 08, 2002 7:08 PM Subject: Brambach Knuckles > The integrated knuckle on some piano hammer shanks, I believe, were first > used by Kimball. Soooo, I have always referred to them a Kimball shanks, > implying that it had an integral knuckle. In fact, I have a few N.O.S. from, > I believe Tuners supply, that was only offered, by them, for a short time. I > have a 194? Kimball Service Manual and it has the specs on how to regulate > them, (with pictures!)<G>. I have forwarded said photos to Jeannie Grassi, > in hopes that this problem system will get published in the PTJ. > Unfortunately, because the manual I have is a "photo copy" type, and the > photos, themselves, are regular photos of grainy quality, it's going to take > someone with digital enhancement know-how to get them readable. > Perhaps, Guru Jack might know the original source of these. > Regards, > Joe Garrett, RPT, (Oregon) > > Been There, Didn't Like It, So I'm Here To Stay! [G} > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC