---------------------- multipart/alternative attachment .> >> >>> >>> . >> Del wrote > A petty point, perhaps, but the amount of compression--i.e., the physical > displacement of the wood cells--is the same in both types of wood. As long > as the hole diameter and the size of the pin remains the same the amount of > compression would also be the same if you used spruce or balsa. The > resistance to that compression, however, is a whole other matter. The > tight-grain maple resists compression much more than does balsa--or the > earlywood of loose-grain maple. Hence the lower force required to drive the > pin into the loose-grain maple--there is much more earlywood in there. > Also, there is less long-term compression set in the latewood of any > species than there is in the earlywood. Not petty but the same ,perhaps more articulate ,but the point remains though ,doesn't it, ? that if one wants a tighter fit pin ( more compression of the wood) in a maple cap with wider grain a smaller hole is required. That was my point. Dale > > ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/93/50/0c/32/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC