>In a message dated 10/24/2002 8:07:55 AM Pacific Daylight Time, >RNossaman@cox.net writes: > > >>Hi Dale, >>The down side is that the Delignit will be less forgiving of differences in >>tuning pin diameter and hole sizing when you drill. If you drilled in one >>pass, you will have more torque variation than if you had drilled two >>passes with 1/4" as the first. What's your finish bit size? >> >>Ron Hey Dale, The invisible italic font doesn't display on this end. Say that again please in something else. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC