---------------------- multipart/alternative attachment In a message dated 10/24/2002 8:07:55 AM Pacific Daylight Time, RNossaman@cox.net writes: > Hi Dale, > The down side is that the Delignit will be less forgiving of differences in > > tuning pin diameter and hole sizing when you drill. If you drilled in one > pass, you will have more torque variation than if you had drilled two > passes with 1/4" as the first. What's your finish bit size? > > Ron ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/0f/36/25/49/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC