I would be interested in what type of release agent/material folks use on the plate flange when epoxy-fitting the block to the flange. You don't want to have to undo cast iron epoxied to hard maple! Terry Farrell ----- Original Message ----- From: "Phillip Ford" <fordpiano@earthlink.net> To: <pianotech@ptg.org> Sent: Thursday, October 24, 2002 10:22 PM Subject: Marking plate for pinblock fitting > I would be interested in the stuff that people are using to mark or coat the > plate flange when fitting a pinblock. > > Phil F > > > > Phillip Ford > Piano Service & Restoration > 1777 Yosemite Ave - 215 > San Francisco, CA 94124 > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC