>Antares wrote: (snip)... > > > We bang on the piano (on the wooden beam that is situated > > against the iron > > frame and directly over the keyboard, what is the name? > > please) and listen > > for a rattle..... > > If we hear a rattle we put one finger lightly on each bolt, > > ubtil we have > > found the one that causes the rattle. > > Tighten bolt, end of story. > > > > > > > > friendly greetings > > from > > > > Antares, > >I think you might have to bang a little less if you were to bang under >the key bed but from below. You would then just have to tap with your >fist and would hear the rattle immediately if there was a gap between >one of the glides. > >Marcel Carey, I don't get it. A little bump of the hand directly on or above each glide bolt will tell you the same thing without having to pound on anything. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC