This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment I've had good results using a hot glue gun. Lay a generous bead = along either the felt or the molding. Hold for about 90 seconds by hand = or with some type of clamp. I've used the mini trigger clamp, and = you're done! Havn't had one fail yet. =20 Mike Kurta ----- Original Message -----=20 From: Jeffrey Schlaybach=20 To: pianotech@ptg.org=20 Sent: Wednesday, August 27, 2003 10:18 AM Subject: Spliting Heads Didn't check the archive but is there a simple way to repair split = hammer heads? I tuned a customer's spinet piano Monday and about 7 of = the heads had the felts pulled away from one side of the hammers (most = on top but some at the bottom). I thought perhaps clamping and glue but = what type of glue? And would the pressure the heads are under allow the = same things to happen all over again? Since it is a spinet I hope to = avoid taking out the action. Jeff Schlaybach - Robesonia, PA ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/51/97/a7/57/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC