----- Original Message ----- From: "Joseph Garrett" <joegarrett@earthlink.net> To: <pianotech@ptg.org> Sent: January 28, 2003 10:45 PM Subject: Drill Press/Greg Newell's question > If there is interest, in this lovely humongous fixture, I'll get one of my > computer types to bring their newest and best digital camera over. > BTW, this fixture was inexpensive to build. The whole design was > specifically for the Radial Arm Drill press. Because of the reach, it needed > mass to be stable, which it definitely is. (The whole thing falls into the > International Harvester Design Category[G]) As does the current version of that radial arm drill press. Don't waste your money on one. I don't think they make dial indicators with enough range to measure the run-out and quill slop.... Del
This PTG archive page provided courtesy of Moy Piano Service, LLC