Terry, Thanks for the info you gave ME! :-) I haven't contacted Phil yet but plan on doing so today or tomorrow. Is this his correct e-mail address? I haven't gone to their web site yet. Sorry. PhilGlenn@yca.tzo.com Avery At 08:14 PM 06/06/03 -0400, you wrote: >Perhaps two things here. The growing brackets I just found were on a YC >serial number 056801. I've heard that the affected brackets were on pianos >with serial numbers starting with "0". Yours appears to be from the same >era as mine. I should think the most definitive way is to measure action >spread. It should be 112.5 mm. The spread on this action was about 122 mm. >Phil Glenn from YC is already in the process of sending me brackets. >Thanks all for the info you gave me. > >Terry Farrell > >----- Original Message ----- >From: "Avery Todd" <avery@ev1.net> >To: "pianotech" <pianotech@ptg.org> >Sent: Friday, June 06, 2003 7:49 PM >Subject: YC Brackets, again > > > > List, > > > > I have some questions about this for those of you who've actually > > been through it. How does one know for SURE that it's the "growing" > > bracket syndrome? > > > > I've never actually seen it personally but I looked at a Young > > Chang G-157, #059894 today that had hammers blocking on the > > strings when the key was played. I could usually trip the jack > > by hand and the hammer would drop some. > > > > What I DIDN'T see was everything I've read about it. I was able > > to easily pull the action out; the drop screws didn't scrape on > > the underside of the pin block, etc. > > > > Besides the blocking, all I could see was that the underside of > > the drop screw was AWFULLY close to the front edge of the wippen > > buckskin and the jacks were mostly WAY too far back under the > > knuckle. > > > > Besides measuring the spread (which I don't know what it's supposed > > to be) how can one know for sure? > > > > It's had water leak/damage in the middle and 1st treble section and > > the string and plate are rusty there. I can also see evidence of it > > by stains on the action rails and a few of the shanks. > > > > I just don't want to do the "growing action brackets" thing without > > being sure. Any ideas how I can BE sure? Thanks. > > > > Avery > > > > _______________________________________________ > > pianotech list info: https://www.moypiano.com/resources/#archives >_______________________________________________ >pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC