Friends, I service an old upright with several very loose low bass tuning pins. Two of them won't even hold a pitch. I tried epoxy on them, but that didn't work. I'd like to try sandpaper in the holes. For those who have done this successfully, what type of sandpaper and what grit do you use? Can I just drive the tuning pin in the hole after fitting a sandpaper shim, or should the pin be turned in? I'd like to give this a try on Monday. Thank you. Sincerely, Clyde Hollinger, RPT Lititz, PA
This PTG archive page provided courtesy of Moy Piano Service, LLC