Terry, There's a good chance you can use a broken screw extractor. A good source is McFeely's, 800-443-7937 Tom Cole Farrell wrote: >Anyone have any good suggestions on how to remove a broken screw from a pinblock? One of the pressure bar screws on the upright I am restringing twisted off. The break is slightly above the pinblock surface, but well below the plate (about a half-inch hole in the plate). I think it is about a #10 screw. > >Just when things were going fairly well........ > >Terry Farrell > >_______________________________________________ >pianotech list info: https://www.moypiano.com/resources/#archives > > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC