In a message dated 18/06/03 7:49:27 PM, fordpiano@earthlink.net writes: << But once I've established the block, drill bit, drill speed combo that..... *gives me the result I want* ........then I can more consistently achieve those same results with the two pass method than with the one pass method. >> Phil; As in so much of what we do, what we desire as a finished procedure plays a role in why we do thingees the way we do........... different strokes and all that! :-) In the final analysis if we end up with a good tuning/feeling pinblock then we have used a 'correct' method...perhaps not 'The Correct' method but then what do I know?? :-) Jim Bryant (FL)
This PTG archive page provided courtesy of Moy Piano Service, LLC