And if you do not have bee's wax see 'Mother' he has some <G> Joe Goss imatunr@srvinet.com www.mothergoosetools.com ----- Original Message ----- From: "Joseph Garrett" <joegarrett@earthlink.net> To: <pianotech@ptg.org> Sent: Friday, June 20, 2003 9:13 AM Subject: Re: New Screws in New Pinblock/Terry's query > Terry, > Here's a "scan" of my assortment. The third from the left and the far right > one are essentially "correct". The others do the job, but need to be remade. > I do this with round files: rat tails, chain saw files, etc. The whole idea > is to have the cutting edge(s) "line" run up the center of the screw, with > the filed out part deep enough to allow the "chips" to have a place to go. > Don't forget to use LOTS of bee's wax! If you do it dry there will be a lot > of "Threads Tearing Out", (my term).<G> > Best Regards, > Joe Garrett, RPT, (Oregon) > > Been There, Didn't Like It, So I'm Here To Stay! [G} > ---------------------------------------------------------------------------- ---- > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC