Baldwin Hamilton loose side panel

[Joe And Penny Goss]

Hey Dean,
I like that idea a lot better than my way. 1/8" drill and vet
1/8" OD long  needle and syringe. I have a dose syringe that would let me
power the glue in. Come to think of it one might even consider using liquid
hide glue.
Now looking for a piano to try it on <G>
Come to think of it this could work on loose bridges from the back?
Joe Goss RPT
Mother Goose Tools
imatunr@srvinet.com
www.mothergoosetools.com
----- Original Message ----- 
From: "Dean May" <deanmay@pianorebuilders.com>
To: "Pianotech" <pianotech@ptg.org>
Sent: Sunday, August 08, 2004 7:40 PM
Subject: RE: Baldwin Hamilton loose side panel


> ProBond makes a urethane glue for a whole lot less than Gorilla brand
> urethane glue. Menards carries it. Urethane glue is activated by moisture,
> so squirt water down into the crack to wet the surfaces before adding the
> glue.
>
> To get glue down into the crack, drill a hole about an inch away from the
> crack down at an angle, so the bit comes out into the crack 2-3 inches
below
> the surface. Inject glue into your new hole, either from a syringe or
> directly from the bottle. Make sure your hole is sized so the syringe tip
or
> glue bottle tip will form a good seal. You will be able to see the glue
fill
> the crack and this technique will get way more glue down there than any
> other method I know of. Drill several holes along the crack. You'll get a
> feel for how far apart to space your holes to fill up the crack.
>
> Blessings,
>
> Dean
>
>
>
> _______________________________________________
> pianotech list info: https://www.moypiano.com/resources/#archives